Trek PZD700A M/S 高壓放大器
Advanced Energy’s precise Trek PZD700A M/S piezo driver and amplifier system’s voltages are customer-specified and factory set.
• Output Voltage: 0 to ±700 VDC or peak AC
• Output Current: 0 to ±200 mA
• Slew Rate: Greater than 380 V/µs
• Large Signal Bandwidth: DC to greater than 150 kHz (-3 dB)
• Gain: 0 to 300 V/V, adjustable
*Specifications shown are for bipolar units, for unipolar operation please refer to data sheet
The Trek® PZD700A M/S piezo driver and amplifier system provides precise voltage control. Its customer-specified voltages are factory set and it features an all-solid-state design, impressive slew rates, and superior bandwidth capabilities.
The Trek PZD700A M/S piezo driver and amplifier system’s input is configured as non-inverting, but an inverting configuration is available. It has a four-quadrant active output stage that sinks or sources the current into reactive or resistive loads throughout the output voltage range.
Benefits
- Rely on ultra-accurate outputs thanks to low-output noise
- Achieve high accuracy via a closed-loop system
- Adjust gain, 0 to 300 V/V
- Save costs thanks to maintenance-free operation and an all-solid-state design
- Safeguard equipment with short-circuit protection
Dimensions: 110 mm H x 432 mm x W 445 mm D (4.3” H x 17” W x 17.5” D)
Weight: 10 kg (22 lb)
HV Connector: SHV High Voltage Connector
Temperature: 0°C to 40°C (32°F to 104°F)
Relative Humidity: To 85%, noncondensing
Altitude: To 2000 meters (6561.68 ft.)
- Precision voltage and current monitors
- Remote access
- Dynamic adjustment optimizes the AC response for various load parameters
- NIST-traceable calibration certificate provided with each unit
- Four-quadrant output for driving capacitive loads
- Piezoelectric driving/control
- Laser modulation
- MEMS
- Semiconductor research
- Piezoelectric vibration damping
