Trek 50/12 高壓放大器
Advanced Energy's Trek 50/12 is DC stable, high voltage amplifier ideal for dielectric and plasma studies, electron beam ion traps and sourcing, electrospinning, electrostatic deflection, and much more.
• Output Voltage Range: 0 to ±50 kV DC or peak AC
• Output Current Range: 0 to ±12 mA DC or peak AC
• Slew Rate: Greater than 350 V/µs
• Large Signal Bandwidth: DC to greater than 1.4 kHz (2% distortion)
• DC Voltage Gain: 5000 V/V fixed
The Trek® 50/12 DC-stable, high-voltage power amplifier features an all-solid-state design for high slew rate, wide bandwidth, and low-noise operation. It is designed to provide precise control of output voltages in the range of 0 to ±50 kV DC or peak AC with an output current range of 0 to ±12 mA DC or peak AC.
The four-quadrant, active-output stage sinks or sources current to reactive or resistive loads throughout the output voltage range. This is essential to achieve accurate output responses and high slew rates demanded by reactive loads.
Benefits
- Drive capacitive loads via a four-quadrant output
- Enable high accuracy thanks to a closed-loop system
- Safeguard equipment with short-circuit protection
- Benefit from nearly maintenance-free operation and solid-state design
- Take advantage of low-output noise and ultra-accurate outputs
Dimensions: 1473.5 mm H x 628.7 mm W 948.4 mm D (58.01” H x 24.75” W x 37.34” D)
Weight: 125-136 kg (275-300 lb)
HV Connector: High Voltage Connector
BNC Connectors: Amplifier Input, Voltage Monitor, Current Monitor, Remote High Voltage ON/OFF, Out of Regulation Status, Fault/Trip Status
Temperature: 0°C to 40°C (32°F to 104°F)
Relative Humidity: To 75%, noncondensing
Altitude: To 1524 meters (5000 ft.)
- Dynamic adjustment optimizes the AC response for various load parameters
- NIST-traceable calibration certificate provided with each unit
- DC-stable for programmable supply applications
- Local and remote high voltage On/Off capabilities
- Switch selectable for current limit or trip
- Dielectric studies
- Electron beam ion traps & ion sources
- Electrospinning
-
Electrostatic deflection
(including Ion beam steering) - Electrostatic flame control
- Electrostatic levitation
- Electrostatic precipitation
- High-voltage cable testing
- High-voltage component testing
-
Plasma studies
(including Dielectric barrier discharge)